Let’s start with a basic health check, which we can use to see how our cluster is doing. We’ll be using curl to do this but you can use any tool that allows you to make HTTP/REST calls. Let’s assume that we are still on the same node where we started Elasticsearch on and open another command shell window.
To check the cluster health, we will be using the _cat API. You can
run the command below in Kibana’s Console
by clicking "VIEW IN CONSOLE" or with curl by clicking the "COPY AS CURL"
link below and pasting it into a terminal.
GET /_cat/health?v
And the response:
epoch timestamp cluster status node.total node.data shards pri relo init unassign pending_tasks max_task_wait_time active_shards_percent 1475247709 17:01:49 elasticsearch green 1 1 0 0 0 0 0 0 - 100.0%
We can see that our cluster named "elasticsearch" is up with a green status.
Whenever we ask for the cluster health, we either get green, yellow, or red.
Note: When a cluster is red, it will continue to serve search requests from the available shards but you will likely need to fix it ASAP since there are unassigned shards.
Also from the above response, we can see a total of 1 node and that we have 0 shards since we have no data in it yet. Note that since we are using the default cluster name (elasticsearch) and since Elasticsearch uses unicast network discovery by default to find other nodes on the same machine, it is possible that you could accidentally start up more than one node on your computer and have them all join a single cluster. In this scenario, you may see more than 1 node in the above response.
We can also get a list of nodes in our cluster as follows:
GET /_cat/nodes?v
And the response:
ip heap.percent ram.percent cpu load_1m load_5m load_15m node.role master name 127.0.0.1 10 5 5 4.46 mdi * PB2SGZY
Here, we can see our one node named "PB2SGZY", which is the single node that is currently in our cluster.