See Also: IDOMConfiguration Members
The DOMConfiguration interface represents the configuration of a document and maintains a table of recognized parameters. Using the configuration, it is possible to change Document.normalizeDocument() behavior, such as replacing the CDATASection nodes with Text nodes or specifying the type of the schema that must be used when the validation of the Document is requested. DOMConfiguration objects are also used in [] in the DOMParser and DOMSerializer interfaces.
The parameter names used by the DOMConfiguration object are defined throughout the DOM Level 3 specifications. Names are case-insensitive. To avoid possible conflicts, as a convention, names referring to parameters defined outside the DOM specification should be made unique. Because parameters are exposed as properties in the , names are recommended to follow the section 5.16 Identifiers of [Unicode] with the addition of the character '-' (HYPHEN-MINUS) but it is not enforced by the DOM implementation. DOM Level 3 Core Implementations are required to recognize all parameters defined in this specification. Some parameter values may also be required to be supported by the implementation. Refer to the definition of the parameter to know if a value must be supported or not.
Note: Parameters are similar to features and properties used in SAX2 [].
The following list of parameters defined in the DOM:
The resolution of the system identifiers associated with entities is done using Document.documentURI. However, when the feature "LS" defined in [] is supported by the DOM implementation, the parameter "resource-resolver" can also be used on DOMConfiguration objects attached to Document nodes. If this parameter is set, Document.normalizeDocument() will invoke the resource resolver instead of using Document.documentURI.
See also the .