Transfers control to a target instruction if the first value is greater than the second value, when comparing unsigned integer values or unordered float values.
Syntax
Remarks
The following table lists the instruction's hexadecimal and Microsoft Intermediate Language (MSIL) assembly format, along with a brief reference summary:
| 41 <int32> |
bge.un target |
Branch to the target instruction at the specified offset if the first value is greater than or equal to the second value (unsigned values). |
The stack transitional behavior, in sequential order, is:
[The 'ordered' type of list has not been implemented in the ECMA stylesheet.]The bge.un instruction transfers control to the specified target instruction if value1 is greater than or equal to value2, when compared using unsigned integer or unordered float values. The effect is identical to performing a clt instruction followed by a brfalse branch to the specific target instruction. The target instruction is represented as a 4-byte signed offset from the beginning of the instruction following the current instruction.
If the target instruction has one or more prefix codes, control can only be transferred to the first of these prefixes. Control transfers into and out of try, catch, filter, and finally blocks cannot be performed by this instruction.
The following ILGenerator.Emit(OpCode) method overload can use the bge.un opcode:
ILGenerator.Emit(OpCode, Label)
Requirements
Assembly: mscorlib (in mscorlib.dll)
Assembly Versions: 1.0.5000.0, 2.0.0.0, 4.0.0.0