Version: 2019.1 (switch to 2018.3 or 2017.4)
LanguageEnglish
  • C#

Joint.autoConfigureConnectedAnchor

Other Versions
Leave feedback
Suggest a change

Success!

Thank you for helping us improve the quality of Unity Documentation. Although we cannot accept all submissions, we do read each suggested change from our users and will make updates where applicable.

Close

Submission failed

For some reason your suggested change could not be submitted. Please <a>try again</a> in a few minutes. And thank you for taking the time to help us improve the quality of Unity Documentation.

Close

Cancel

public bool autoConfigureConnectedAnchor;

Description

Should the connectedAnchor be calculated automatically?

If this is enabled, then the connectedAnchor property will be calculated automatically to match the global position of the anchor property. This is the default behavior. If this is disabled, you can configure the position of the connected anchor using the connectedAnchor property.

Did you find this page useful? Please give it a rating:

Is something described here not working as you expect it to? It might be a Known Issue. Please check with the Issue Tracker at issuetracker.unity3d.com.

Copyright © 2019 Unity Technologies. Publication: 2019.1-002V. Built: 2019-04-15.
TutorialsCommunity AnswersKnowledge BaseForumsAsset Store