Version: 2019.1 (switch to 2018.3 or 2017.4)
LanguageEnglish
  • C#

SpeedTreeImporter.enableSubsurface

Suggest a change

Success!

Thank you for helping us improve the quality of Unity Documentation. Although we cannot accept all submissions, we do read each suggested change from our users and will make updates where applicable.

Close

Submission failed

For some reason your suggested change could not be submitted. Please <a>try again</a> in a few minutes. And thank you for taking the time to help us improve the quality of Unity Documentation.

Close

Cancel

Switch to Manual
public bool[] enableSubsurface;

Description

Gets and sets an array of booleans to enable Subsurface effect for each LOD (affects only SpeedTree v8 assets).

This setting controls the light scattered out the back side of leaves and other two-sided SpeedTree materials. Because the sub-surface scattering effect comes with an increased performance cost, you may want to only enable it on the SpeedTree assets that are nearest to the player. You can use this feature to improve performance by disabling the sub-surface scattering effect on some of your less detailed LOD levels where the models are far enough away from the camera that the absence of this effect is not noticeable. The array length that you supply must match the number of LOD levels in your SpeedTree asset, and typically would have true values at the start, and false values at the end. For example, if your SpeedTree asset has 3 LOD levels, you might pass an array of [ true, true, false ] to enable the sub-surface scattering effect on the first two LOD levels, but disable it on the third.

Did you find this page useful? Please give it a rating: