Version: 2019.1 (switch to 2018.3 or 2017.4)
LanguageEnglish
  • C#

JointLimits

struct in UnityEngine

/

Implemented in:UnityEngine.PhysicsModule

Suggest a change

Success!

Thank you for helping us improve the quality of Unity Documentation. Although we cannot accept all submissions, we do read each suggested change from our users and will make updates where applicable.

Close

Submission failed

For some reason your suggested change could not be submitted. Please <a>try again</a> in a few minutes. And thank you for taking the time to help us improve the quality of Unity Documentation.

Close

Cancel

Description

JointLimits is used by the HingeJoint to limit the joints angle.

See Also: HingeJoint.

using UnityEngine;

public class Example : MonoBehaviour { void Start() { // Set the hinge limits for a door. HingeJoint hinge = GetComponent<HingeJoint>();

JointLimits limits = hinge.limits; limits.min = 0; limits.max = 90; limits.bounciness = 0; limits.bounceMinVelocity = 0; hinge.limits = limits; } }

Properties

bounceMinVelocityThe minimum impact velocity which will cause the joint to bounce.
bouncinessDetermines the size of the bounce when the joint hits it's limit. Also known as restitution.
contactDistanceDistance inside the limit value at which the limit will be considered to be active by the solver.
maxThe upper angular limit (in degrees) of the joint.
minThe lower angular limit (in degrees) of the joint.

Did you find this page useful? Please give it a rating: