Start containers automatically

Estimated reading time: 3 minutes

Docker provides restart policies to control whether your containers start automatically when they exit, or when Docker restarts. Restart policies ensure that linked containers are started in the correct order. Docker recommends that you use restart policies, and avoid using process managers to start containers.

Restart policies are different from the --live-restore flag of the dockerd command. Using --live-restore allows you to keep your containers running during a Docker upgrade, though networking and user input are interrupted.

Use a restart policy

To configure the restart policy for a container, use the --restart flag when using the docker run command. The value of the --restart flag can be any of the following:

Flag Description
no Do not automatically restart the container. (the default)
on-failure Restart the container if it exits due to an error, which manifests as a non-zero exit code.
always Always restart the container if it stops. If it is manually stopped, it is restarted only when Docker daemon restarts or the container itself is manually restarted. (See the second bullet listed in restart policy details)
unless-stopped Similar to always, except that when the container is stopped (manually or otherwise), it is not restarted even after Docker daemon restarts.

The following example starts a Redis container and configures it to always restart unless it is explicitly stopped or Docker is restarted.

$ docker run -dit --restart unless-stopped redis

Restart policy details

Keep the following in mind when using restart policies:

  • A restart policy only takes effect after a container starts successfully. In this case, starting successfully means that the container is up for at least 10 seconds and Docker has started monitoring it. This prevents a container which does not start at all from going into a restart loop.

  • If you manually stop a container, its restart policy is ignored until the Docker daemon restarts or the container is manually restarted. This is another attempt to prevent a restart loop.

  • Restart policies only apply to containers. Restart policies for swarm services are configured differently. See the flags related to service restart.

Use a process manager

If restart policies don’t suit your needs, such as when processes outside Docker depend on Docker containers, you can use a process manager such as upstart, systemd, or supervisor instead.

Warning: Do not try to combine Docker restart policies with host-level process managers, because this creates conflicts.

To use a process manager, configure it to start your container or service using the same docker start or docker service command you would normally use to start the container manually. Consult the documentation for the specific process manager for more details.

Using a process manager inside containers

Process managers can also run within the container to check whether a process is running and starts/restart it if not.

Warning: These are not Docker-aware and just monitor operating system processes within the container.

Docker does not recommend this approach, because it is platform-dependent and even differs within different versions of a given Linux distribution.

Rate this page:

 
141
 
34