Add SANs to cluster certificates

UCP always runs with HTTPS enabled. When you connect to UCP, you need to make sure that the hostname that you use to connect is recognized by UCP’s certificates. If, for instance, you put UCP behind a load balancer that forwards its traffic to your UCP instance, your requests will be for the load balancer’s hostname or IP address, not UCP’s. UCP will reject these requests unless you include the load balancer’s address as a Subject Alternative Name (or SAN) in UCP’s certificates.

If you use your own TLS certificates, make sure that they have the correct SAN values. Learn about using your own TLS certificates.

If you want to use the self-signed certificate that UCP has out of the box, you can set up the SANs when you install UCP with the --san argument. You can also add them after installation.

Add new SANs to UCP

1. In the UCP web UI, log in with administrator credentials and navigate to the Nodes page.
2. Click on a manager node, and in the details pane, click Configure.
3. In the SANs section, click Add SAN, and enter one or more SANs for the swarm.
4. Once you’re done, click Save.

You need to do this on every manager node in the swarm, but once you have done so, the SANs are applied automatically to any new manager nodes that join the swarm.

You can also do this from the CLI by first running:

$ docker node inspect --format '{{ index .Spec.Labels "com.docker.ucp.SANs" }}' <node-id>
default-cs,127.0.0.1,172.17.0.1

This will get the current set of SANs for the given manager node. Append your desired SAN to this list, for example default-cs,127.0.0.1,172.17.0.1,example.com, and then run:

$ docker node update --label-add com.docker.ucp.SANs=<SANs-list> <node-id>

<SANs-list> is the list of SANs with your new SAN appended at the end. As in the web UI, you must do this for every manager node.